beautypg.com

Drive shaft assembly, Warning – Echo SHC-265 User Manual

Page 24

background image

24

Drive Shaft Assembly

Level 1.

NOTE

Hedge Clipper drive shaft should be greased every 25 hours of

operation.

Tools required: 4 mm hex wrench, clean rag, small brush.
Parts required: POWER BLENDX

TM

14 oz. cartridge P/N 91015 or

Lithium Based Grease.

WARNING

Hedge Clipper blades are very sharp. Touching them may lead to

severe personal injury. Avoid touching blades whenever possible,

and always wear gloves to protect hands.

1. Remove gear housing locating screw (A) and clamping screw (B).

Remove the gear housing assembly from the drive shaft housing.

2. Pull the drive shaft (C) from the housing, wipe clean and re-coat

with a thin coating [1/2 oz. (15 ml)] of grease.

3. Slide the flexible shaft back in the drive housing being careful not

to get dirt on the flex shaft.

4. Install the gear housing assembly.

IMPORTANT

Flat edge of washer (D) must be against drive shaft.

A

b

C

d