Envision Peripherals EN-8500 - Manual (Page 9)

EN-8500
8
INSTALLATION INSTRUCTIONS
POWER CORD
Power Source:
1. Make sure the power cord is the correct type that required in your area.
2. This LCD monitor has a universal power supply that allows operation
from100 - 240V AC voltage area (No user adjustment is required.)
3. Connect the Power Adapter’s DC cord into your LCD monitor’s power
input socket. Then connect the male side of the power cord into a 3-pin
AC power outlet. Connect the other end of the power cord to the Power
Adapter. The power cord may be connected to either a wall power outlet
or the power outlet socket on your PC, depending on the type of power
cord supplied with your LCD monitor.
A certified power supply cord has to be used with this equipment. The
relevant national installation and/or equipment regulations shall be
considered. A certified power supply cord not lighter than ordinary polyvinyl
chloride flexible cord according to IEC 60227 (designation H05VV-F 3G
0.75mm or H05VVH2-F2 3G 0.75mm ) shall be used. Alternative a flexible
cord be of synthetic rubber according to IEC 60245 (designation H05RR-F 3G
0.75mm ) shall be used.
INSTALLATION INSTRUCTIONS