En-8500 – Envision Peripherals EN-8500 User Manual
Page 32

EN-8500
31
4.
Setting up MPAA rating Mode – Select MOVIE GUIDELINES from the
V-Chip menu.
-
Use Up/Down/Left/Right arrow buttons to move around the matrix
and press Menu button to change the value from “U” to ‘B” or “B”
to “U”
-
MPAA : Motion Picture Association of America [movie rating
organization]
G
U General
Guidance
PG
U Parental
Guidance
Suggested
PG-13
U
Parents Strongly Cautioned
R
U
Restricted Under 17 Requires
NC-17
U
No Children Under 17 Admitted
X
U Adult
NR
U Not
Rated
5.
Entering a new pin number - Select CHANGE PIN NUMBER from the
V-Chip menu.
-
Use numeric keys enter a new pin number. Pin number confirm
menu appears.
-
Again, use numeric keys to enter the pin number you entered at
the previous step. If the two pin numbers do not match,
“ Incorrect “ message will be displayed.
-
If you forget your pin number, you can reset it to the default
“0000” by following the procedure below.
-
Press Menu (VIDEO ADJUST will be selected by default).
-
Press Menu. Then press CH-down to highlight RECALL.
-
Press Menu to execute RECALL.
6. Blocking
Screen
-
If the incoming signal’s rating is higher than the one specified, the
screen will be blanked and the excessive rating message will be
appeared.
NOTE: When the screen is blocked by V-Chip, and if you want to change V-
Chip setting, press Exit button on the remote control or auto/exit key
on the front cabinet of the monitor to bring up OSD Menu.