En-8500 – Envision Peripherals EN-8500 User Manual
Page 26

EN-8500
25
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected , If the connector is
loose, tighten the connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode ,Set the computer to
display mode given in the following table.
VIDEO/TV NO SIGNAL :
You set the monitor to the VIDEO /TV mode but there is no video/TV signal
input. Check to make sure that the video/TV signal cable is properly
connected and make sure the video player is working.
If the monitor is stuck in “Power Saving” mode:
1. Make sure monitor’s signal-cable is properly connected to the computer.
2. The computer has switched the monitor into power save mode. Press
any key on the computer keyboard to wake up the monitor.
3. Check that the computer is switched on.
4. Check the computer resolution, rate may be too high and out of the LCD-
MONITOR’s display mode range.
RESOLUTION :
RESOLUTION
VERTICAL
FREQUENCY
RESOLUTION
VERTICAL
FREQUENCY
640 × 480
60Hz
800 × 600
60.3Hz
640 × 350
70Hz
800 × 600
72.2Hz
720 × 400
70Hz
800 × 600
75Hz
640 × 480
72.8Hz
832 × 624
74.5Hz
640 × 480
75Hz
1024 × 768
60Hz
640 × 480
66.67Hz
1024 × 768
70Hz
800 × 600
56.3Hz
1024 × 768
75Hz
1024 × 768
74.92Hz
ERROR MESSAGE & POSSIBLE SOLUTION