Eaton Electrical 34003991EN/EB - Manual (Page 74)

Network Management Card – User Manual 34003991EN/EB Page 74/118
6.2.2 Choice 2: Modify Network settings
Enables the modification of network parameters
For each of the following questions, you can press to select the value
shown in braces, or you can enter a new value.
Should this target obtain IP settings from the network?[N]
Static IP address [166.99.18.129]?
Subnet Mask IP address [255.255.248.0]?
Gateway address IP address [166.99.17.1]?
Wait during your new configuration is saved ...
Reset the card to take into account the new configuration.
In DHCP mode, the card can receive the following parameters according to the DHCP server settings
◗ IP address
◗ Subnet Mask
◗ Gateway address
◗ Primary DNS server
◗ Secondary DNS server
The card must be restarted in order for the new parameters to be taken into account.
6.2.3 Choice 3: Set Ethernet speed
Enables the modification of the network speed
Set the Ethernet speed : [1 : Automatic, 2 : 10 MBit]
1
New Ethernet speed : Automatic
Wait during the new setting is saved ...
Reset the card to take into account the new configuration.
The card must be restarted in order for the new parameters to be taken into account.