Eiki LC-SD12 - Manual (Page 13)

13
– This projector is designed to project on a flat projection surface.
– The projector can be focused from 4.3’(1.3m) to 21.3’(6.5m).
– Refer to the figure below to adjust the screen size.
40”
100”
150”
200”
169”
127”
83”
34”
A
B
21.3’ (6.5m)
16.1’ (4.9m)
10.6’ (3.2m)
4.3’ (1.3m)
Max. Zoom
Min. Zoom
A : B = 9 : 1
Screen Size
(W x H) mm
4 : 3 aspect ratio
Zoom (min)
40”
Zoom (max)
813 x 610
4.9' (1.5m)
4.3’ (1.3m)
100”
2032 x 1524
12.5' (3.8m)
10.6’ (3.2m)
150”
3048 x 2286
19.0' (5.8m)
16.1' (4.9m)
200”
4064 x 3048
–––––
21.3’ (6.5m)
34"
691 x 518
4.3’ (1.3m)
–––––
Note:
The brightness in a room has a great influence on the
picture quality. It is recommended to limit ambient lighting
in order to provide the best image.
Center
Adjustable Feet
The picture tilt and the projection angle can be adjusted by rotating
the adjustable feet. The projection angle can be adjusted at 8.0
degrees.
Lift the front of the projector and pull the feet lock latches on
the both sides of the projector. 1
Adjustable Feet
Feet Lock
Latches
Release the feet lock latches to lock the adjustable feet and
rotate them to adjust position and tilt. 2
To retract the adjustable feet, lift the front of the projector
and pull and undo the feet lock latches.
Keystone distortion of the projected image can be adjusted
by the Menu Operation. (
☞ P20, P36 )
3
CAUTION
Tilt the projector within the adjustable angle not to shorten the lamp life.
Proper angle should be taken.
Positioning the Projector
Installation
Installation