Powerplus POWXQG7510 LAWNMOWER 1800W 460MM EN - Manual (Page 8)

POWXQG7510 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
6.3 Adjustment of cutting height (7)
Apply outward pressure to disengage lever from rack. Move lever forward or back to adjust
height. (Fig 3)
The height (the blade to the ground) can be adjusted from 30mm (the lowest position) to
90mm (the highest position), 7 height positions (30mm/ 40mm/ 50mm/ 60mm/ 70mm/ 80mm/
90mm).
Warning: Make this adjustment only when blade is stopped.
6.4 Adjustment for an appropriate angle (Fig 4)
 Pull the locking lever opening.
 By rotating the upper handle, which acts on the adjustment mechanism for angle
adjustment, a suitable angle can be adjusted in the range of -20 º to 20 º
 Push the locking lever closed to connect the lower handle and the upper handle.
7 MULCHING
7.1 What is mulching
When mulching, the grass is cut in one working step, then finely chopped and returned to the
grass strip as natural fertilizer.
Hints for mulch-mowing:
 Regular cut-back by max.2cm from 6cm to 4cm grass height.
 Use a sharp cutting knife
 Do not mow wet grass
 Set to max. motor speed
 Only move at working pace
 Regularly clean mulching wedge, housing inner side and mowing blade
7.2 Different uses
7.2.1 Mulching mower
WARNING: only with a stopped motor and standstill cutter.
 Raise the rear cover and remove the grass catcher. (Fig A)
 Push the mulching wedge into the deck. Lock the mulching wedge with the button into the
opening on the deck.
 Lower the rear cover again. (Fig 5B)
7.2.2 Mowing with the grass catch bag
WARNING: only with a stopped motor and standstill cutter.
 For mowing with the grass catch bag, remove the mulching wedge and mount the grass
catch bag.
 Removing the mulching wedge.

Lift rear cover and remove the mulching wedge.
8 SAFETY PRECAUTIONS (FIG 6)
 Always operate with the deflector or grass catcher in the correct position.
 Always stop the motor before removing the grass catcher or adjusting the height of cutting
position.