Powerplus POWXQ5350 MITRE SAW +UPPER TABLE 1800W 305MM EN - Manual (Page 9)

POWXQ5350
EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
 Make sure that any spacers and spindle rings used are suitable for the purpose as stated
by the manufacturer.
8 ELECTRICAL SAFETY
Check the voltage that is documented on the type plate of the machine, to
make sure that it corresponds to the locally available mains voltage.
Safety class II.
9 SPECIAL PRODUCT CHARACTERISTICS
 Quick change-over between cross-cut and table saw mode.
 45° sawing range for bevelling (45° left).
 98° sawing range for mitre sawing (49° left or 49° right) with ten preset stops.
 Robust, cast aluminum construction for precision sawing.
 Installation of additional guides possible.
 After an interruption of the power supply, a restart protection prevents that the machine
starts up again when the power supply is restored.
10 INSTALLATION AND TRANSPORT
Do not carry the machine on the handgrip; the handgrip is not designed to
carry the full weight of the machine.
For carrying the machine, hold it on both edges of the base .
10.1 Installation
 Get help from another person for lifting the machine out of the box.
 Turn the turntable into the 0° position and tighten up the mitre locks.
Note: If the machine must be mounted on a workbench, then the rubber feet
should NOT be installed.
You run the risk of injury, if you handle the machine incorrectly when lifting
or turning it. Always hold the machine firmly by the base.
 Position the machine on a suitable surface:
o All 4 feet must rest firmly on the surface.
o The ideal height of the surface is approximately 800 mm.
o The saw must stand firmly in position, even when larger workpieces are being sawn.
o An additional support at the back of the machine has to be pull out.
 You can keep the packaging for future use, or you can dispose of it separately, based on
the type of material, and it in an environmentally friendly manner.
10.2 Transport (30)
 Position the lowest saw blade guard over the saw guide piece and push backwards until
you hear a click, and until he saw blade protector is positioned at the black line on the saw
guide piece.
 Lower the saw head by pushing in the safety lock and activate the locking pin.
 Lift the machine up by grasping both sides of the base.