Powerplus POWXQ5350 MITRE SAW +UPPER TABLE 1800W 305MM EN - Manual (Page 11)

POWXQ5350
EN
Copyright © 2014 VARO P a g e | 11 www.varo.com
 The air flow volume must exceed 550 m³/h;
 The vacuum at the dust exhaust
exit must be ≥ 740 Pa;
 The air speed at the dust exhaust exit must be ≥ 20 m/s;
 Follow the user instructions for the dust collector.
10.2.7 Connection to AC power
High-voltage!
 Only operate this machine in dry surroundings.
 This machine may only be connected to a power source that fulfils the following
requirements (also see the section "Technical data"):
o The mains voltage and the system frequency must conform to the voltage and
frequency that is indicated on the technical data sheet of the machine;
o Fusing protection with a residual current device (RCD), with a sensitivity of 30 mA.
o Sockets must be properly installed, earthed and tested.
o Position a power cable in such a way that it does not hinder the work and cannot be
damaged.
 Protect the power cable against heat, aggressive fluids and sharp edges.
 Only use rubber-coated extension cables with a sufficient wire cross-section (3 x 1.5
mm²).
 Do not use the power cable for pulling the plug out of the socket.
11 OPERATION
This saw can be used as a:
 Cross-cut saw
 Table saw
Before making any changes in the settings of this machine, always remove
the plug from the socket.
11.1 Cross-cut sawing mode
11.1.1 Safety instructions for the movable saw blade guard (Fig. 2)
The movable saw blade guard protects against accidental contact with the saw blade and
flying wood splinters.
The movable saw blade guard must always return automatically to the start position, whenever
the saw head is lifted. The saw blade must be covered at all sides, when the saw head is
located in the start position.
11.1.2 Safety lock (Fig. 3)
The safety lock blocks the saw head in the topmost position, and it prevents that the movable
saw blade guard exposes the saw blade.
The safety lock is released by pushing on it. The saw head can now be lowered; as the saw
head is lowered, the saw blade guard retracts and the saw blade is freed.
After a cut has been made, and when the saw head is back in the topmost starting position,
the movable saw blade guard is once more blocked by the safety lock.