Powerplus POWXG8015LI CHAINSAW 18V LI-ION 254MM ONE FITS ALL EN - Manual (Page 8)

POWXG8015LI EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
 Always pull the plug from the socket outlet before attempting to check or adjust the chain
or to correct some fault and whenever moving one workplace to another.
 Never switch on the chain saw unless you have a firm hold of the tool. a secure footing
and are sure that the guide bar and saw chain are not touching anything.
 Always hold the saw with both hands (right hand on rear handle, left hand on handle ( 2).
 Never saw above shoulder height, while standing on a ladder or In a tree or in any other
insecure position.
 When sawing timber that has split, take particular care that no small pieces of wood are
broken off and thrown by the saw chain.
 During breaks, the saw should be laid down in such a way that there Is no risk of injury to
anyone from the saw chain.
 The chain saw should never be lent to or be allowed to come into the hands of persons
who are not familiar with the use of such a tool. The operating Instructions should also go
with the saw.
7 KICKBACK
In order to prevent kick-back, please follow these safety instructions:
 Never start cutting with the tip of the guide bar!
 Never cut with the tip of the guide bar! Be careful, when continuing cuts you are already
working on!
 Always start cuts with the chainsaw already running!
 Make sure that the saw chain is always properly sharpened.
 Never cut through more than one branch at a time! When lopping off branches, be careful
not to touch any other branches.
 When cross-cutting, pay attention to trunks standing very close to each other. If possible
use a saw-horse.
8 TRANSPORTING THE CHAINSAW
Before transporting the chainsaw, always remove the plug from the power socket and slide the
chain guard over the rail and chain. If several cuts are to be performed with the chain saw, the
saw must be switched off between cuts.
9 BEFORE USING THE TOOL FOR THE FIRST TIME
9.1 Advantage of Li-ion batteries.
 40% More Performance
 40% Less Weight
 100% Longer Life
 40% More Compact
 No Memory Effect
 Environment-Friendly
9.2 Charging Procedure
The charging procedure starts as soon as the mains plug of the charger is plugged into a
power socket and the battery (14) is inserted into the charging compartment (13).
Thanks to the intelligent charging PCB (Protective circuit board), the charging condition of the
battery is automatically detected and the battery is charged in optimum condition.
(PCB takes into account : Over Charging/Discharging, Voltage and Current, Battery
temperature, Short-Circuit, Overload, Each Cell Unbalance (Out-put, In-put), resulting in
continuous optimum Voltage & Current when Charging or Working.
This gives longer life to the battery and always leaves it fully charged when kept in the charger
for storage.
Charge battery pack only with the charger provided.