Powerplus POWXG8015LI CHAINSAW 18V LI-ION 254MM ONE FITS ALL EN - Manual (Page 14)

POWXG8015LI EN
Copyright © 2014 VARO P a g e | 14 www.varo.com
 Dismantle the chain cover, the saw chain and the sawing bar.
 Clean the oil guide groove using a suitable tool (e.g., wire brush).
 Mount the saw chain, the sawing bar and the chain cover.
Sawing bar wear
 The sawing bar of the device becomes worn out over time.
 After cleaning it, turn the sawing bar around by 180°. This balances the wear and tear and
enhances the service life of the sawing bar.
14 TROUBLESHOOTING
FAULT CAUSE REMEDY
Chain becomes hot Excessive chain tension Adjust the chain tension
Excessive friction on account of
inadequate lubrication Fill up the oil tank
Saw chain is blunt Look for a service
workshop
The saw chain is dry No oil in the tank Fill up the oil tank
Oil guide groove is clogged Clean the sawing bar
The engine is not running The battery is discharged or
defective Charge the battery or
replace it.
The battery is too hot or too cold Allow the battery to cool
down or warm up
Noisy operation, excessive
vibration of the device Inadequate chain tension Adjust the chain tension
Saw chain mounted in the wrong
direction of movement Mount the saw chain
correctly
Saw chain or sawing bar
defective Look for a service
workshop