Powerplus POWXG6007 LAWNMOWER 190CC 510MM EN - Manual (Page 13)

POWXG6007
EN
Copyright © 2011 VARO P a g e | 13 www.varo.com
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Spark plug wire loose or
disconnected from plug. Install spark plug wire on spark
plug.
Spark plug gap is incorrect. Set gap between electrodes at 0.6
to 0.7mm
Spark plug is defective Install new, correctly gapped plug:
refer to ENGINE OWNERS
MANUAL
Carburetor is flooded with fuel Remove air cleaner element and
pull starter rope continuously until
carburetor clears itself and install
air cleaner element.
Faulty ignition module Contact the service agent.
Engine difficult to
start or loses power. Dirt, water, or stale fuel tank. Drain fuel and clean tank. Fill tank
with clean, fresh fuel
Vent hole in fuel tank cap is
plugged. Clean or replace fuel tank cap.
Air cleaner element is dirty. Clean air cleaner element.
Engine operates
erratically. Spark plug is defective. Install new, correctly gapped plug:
refer to ENGINE OWNERS
MANUAL
Spark plug gap is incorrect. Set gap between electrodes at 0.6
to 0.7mm
Air cleaner element is dirty. Clean air cleaner element: refer to
ENGINE OWNERS MANUAL
Engine idles poorly. Air cleaner element is dirty. Clean air cleaner element: refer to
ENGINE OWNERS MANUAL
Air slots in engine shroud are
blocked. Remove debris from shots.
Cooling fins and air passages
under engine blower housing are
blocked. Remove debris from cooling fins
and air passages.
Engine skips at high
speed. Gap between electrodes of spark
plug is too close. Set gap between electrodes at 0.6
to 0.7mm
Engine overheats Cooling air flow is restricted. Remover any debris from slots in
shroud, blower housing, air
passages
Incorrect spark plug. Install FGRTC spark plug and
cooling fins on engine
Mower vibrates
abnormally Cutting assembly is loose. Tighten blade
Cutting assembly is unbalanced Balance blade.
13 WARRANTY
This product is warranted as provided by law for a 36 months period effective from the date
of purchase by the first user.
This warranty covers all material or production flaws. It does not include: defective parts
subject to normal wear & tear, such as bearings, brushes, cables, plugs or accessories
such as drills, drill bits, saw blades etc. ; damage or defects resulting from abuse, accidents
or alterations; nor the costs for transport.