Powxg6007 – Powerplus POWXG6007 LAWNMOWER 190CC 510MM EN User Manual

Page 10

POWXG6007

P a g e

| 10

The engine air cleaner element must be serviced (cleaned) after 25 hours normal mowing.
The foam element must be serviced regularly if the mower is used in dry dusty conditions.
To CLEAN AIR FILTER
1.

Remove screw.

Press down the two tabs on top of the filter cover. Remove cover.

Wash filter element in soap water. DO NOT USE GASOLINE!

Air dry filter element.

Place a few drops of SAE30 oil on the foam filter and squeeze tightly to remove any
excess oil.

Reinstall filter.

NOTE: Replace filter if frayed, torn, damaged or unable to be cleaned.

Fig 10

9.2

Cutting blade

CAUTION: Be sure to disconnect and ground the spark plug wire before
working on the cutting blade to prevent accidental engine starting. Protect
hands by using heavy gloves or a rag to grasp the cutting blades.

Tip mower :

When the mower is tipped over onto its side, please take care that the air cleaner

is on the top side

. Remove the hex bolt and washer which hold the blade and blade adapter

to the engine crankshaft. Remove the blade and adapter from the crankshaft.

WARNING: Periodically inspect the blade adapter for cracks, especially if
you strike a foreign object. Replace when necessary.

For best results your blade should be sharp. The blade may be resharpened by removing it
and either grinding or filing the cutting edge keeping as close to the original bevel as possible.
It is extremely important that each cutting edge receives an equal amount of grinding to
prevent an unbalanced blade. Improper blade balance will result in excessive vibration
causing eventual damage to the engine and mower. Be sure to carefully balance blade after
sharpening. The blade can be tested for balance by balancing it on a round shaft screwdriver.
Remove metal from the heavy side until it balances evenly.

www.varo.com

The engine air cleaner element must be serviced (cleaned) after 25 hours normal mowing.
The foam element must be serviced regularly if the mower is used in dry dusty conditions.

Place a few drops of SAE30 oil on the foam filter and squeeze tightly to remove any

CAUTION: Be sure to disconnect and ground the spark plug wire before
working on the cutting blade to prevent accidental engine starting. Protect

heavy gloves or a rag to grasp the cutting blades.

When the mower is tipped over onto its side, please take care that the air cleaner

. Remove the hex bolt and washer which hold the blade and blade adapter

shaft. Remove the blade and adapter from the crankshaft.

WARNING: Periodically inspect the blade adapter for cracks, especially if

ned by removing it

and either grinding or filing the cutting edge keeping as close to the original bevel as possible.
It is extremely important that each cutting edge receives an equal amount of grinding to

ce will result in excessive vibration

causing eventual damage to the engine and mower. Be sure to carefully balance blade after
sharpening. The blade can be tested for balance by balancing it on a round shaft screwdriver.