Powerplus POWX093 ROUTER 1500W +12 ROUTER BITS EN - Manual (Page 9)

POWX093
EN
Copyright © 2013 VARO P a g e | 9 www.varo.com
6.11 Cutting in serval operations
For cutting in depth and in stages, use the length-stop turret as
an aid. Using the depth scale, set the desired depth to the
lowest depth-stop position on the turret. Rotate the turret so that
the highest point is under the depth stop and execute the first
cut (23). Repeat the cut with the second-highest
setting and finally with the last setting. You can also use two
positions if the desired depth is reached in two operations..
6.12 Switching on and off
Grasp the machine securely at the handles. When it is pointing
in your direction, the start-stop button is located on the right
handle (24}. Keeping the safety lock pressed, press the start-
stop button. You do not have to keep the safety lock pressed as
it remains in position automatically until you release the start-
stop button again. To stop the machine, simply release the start-
stop button and the motor stops..
6.13 Adjustable speed
The speed setting is located at the front of th e h o usi ng (25).
Turn the knob to increase or decrease the speed. The smaller
the cutter head, the higher the speed.The larger the cutter
head, the lower the speed. A cutter head which runs too fast
causes scorching of the workpiece and leaves burnt marks.
CAUTION: Do not change the speed when the machine is
working under load.
6.14 Using the parallel guide
he parallel guide can be used for cutting parallel to the edge
of the workpiece. Release the four screws securing the
parallel guide and push them in so that the guide is at the
desired distance from the cutter head. Tighten the four
securing screws. Press the guide securely against the edge of
the workpiece and execute the cut.
CAUTION: Abnormal vibrations may be due to a blunt cutter
head.
6.15 Cutting direction
To prevent the cutter head from jumping and to obtain a good
result, carry out exterior cuts in anticlockwise and interior cuts
in clockwise direction (27).
6.16 Replacing the carbon brushes