Powerplus POWX093 ROUTER 1500W +12 ROUTER BITS EN - Manual (Page 6)

POWX093
EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
6 OPERATION
6.1 Depth Stop
Locate the depth stop on the left-hand side of the cutting machine. This continuously
adjustable stop is intended to limit the depth of the cut. Locate the fixing screw for the depth
stop (1). Loosen it by turning it in anticlockwise direction. To move the depth stop up or down,
turn the stop adjuster in clockwise or anticlockwise direction (2).
6.2 Locking lever for cutting machine body
When viewed from the front, the locking lever (3) is located at the rear on the left-hand side.
The cutting machine body is spring-tensioned. Take care when releasing the locking lever.
Grasp both handles and brace yourself before releasing the lever (4). Press downwards to
allow the cutting machine body to move down. When you reduce the downward pressure, the
springs force the cutting machine body back up into its highest position.
CAUTION: The housing of the machine is under spring tension. When you release the locking
lever, it returns to its highest position..
6.3 Dust extraction outlet
You are advised to use the dust extraction outlet. You can purchase
a suitable commercial vacuum cleaner or extract the dust via an
extractor tube while the cutting machine is in operation. The outlet
must project out of the rear of the machine (5). Two bolts and nuts
are supplied to attach it.
Hold the extractor outlet in position and lay the cutting machine on its side. Push the long bolt
through the machine base until it projects at the fastening point for the extractor outlet (6).
Place the nut in the hexagon-shaped recess (7). Tighten the bolt with a suitable wrench and
moderate force until the outlet is securely attached. Repeat the procedure at the other side.
CAUTION: Dust may cause respiratory problems. Certain laminated board
materials are carcinogenic. After work, always remove all dust from the
machine.