Powerplus POWX093 ROUTER 1500W +12 ROUTER BITS EN - Manual (Page 5)

POWX093
EN
Copyright © 2013 VARO P a g e | 5 www.varo.com
 If devices are provided for the connection of dust extraction and collection facilities,
ensure these are connected and properly used. Use of these devices can reduce dust
related hazards.
4.4 Power tool use and care
 Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
 Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
 Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
par ts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
 Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
4.5 Service
 Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
5 SPECIFIC SAFETY WARNINGS
 Ensure that the power lead does not come into contact with the milling cutter.
 Ensure that the lifting rods are firmly seated on the housing and cannot work loose while
working.
 Pull out plug before inserting milling cutter.
 Ensure that milling cutter is firmly clamped.
 Use only milling cutters for routers; never use e.g. milling cutters for drilling machines or
stationary machines.
 Use only commercially available milling cutters for routers with a shank diameter 6 mm or
8 mm.
 Always use both hands to guide the tool.
 Never wedge the ON switch fast.
 Never reach into the milling zone while the tool is running.
 Feed only running milling cutters to the material.
 Note direction of cut - always move the cutter against the material.
 When work is finished, remove the milling cutter from the tool.
 Wood dust set up during work is harmful to health. Always work with dust collector
operating.
 Wear protective goggles, ear protectors and, if necessary, breathing mask.
 Observe general safety regulations for handling and using electric tools..