Powerplus POWX0550 CIRCULAR SAW 1800W 210MM EN - Manual (Page 6)

POWX0550
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 Only put the machine aside after switching off and when the saw blade has come to a
complete standstill.
 Never try to slow the saw blade down by exerting pressure on the side.
 Before performing maintenance to the machine, always unplug the machine.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
Leaser beam warning
Laser beam characteristics
 Warning! The laser beam potentially causes severe eye damage. Never look or stare
directly into the leaser beam.
 During use, do not point the laser beam at people, directly or indirectly through reflecting
surfaces.
 This laser complies with class 2 according to EN 60825-1:2007. The unit includes no
servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent.
8 ADJUSTMENTS.
8.1 Replacing the saw blade (Fig. 1)
Only use sharp and undamaged saw blades. Cracked or bent saw blades must be replaced
immediately.
 Place this circular saw on its side on a flat surface. Advice you bring the base plate (10)
down as if a minimum depth cut which is ease to operate.
 Push the spindle lock button toward motor housing as the arrow shows in Fig. 1 and firmly
hold it.
 Turn the blade clamp bolt anti-clockwise by using the spanner that supplied with the tool.
 Remove the blade clamp bolt and outer flange.
 Raise the lower guard (16) by using the lever for lower guard (17), and then remove the
saw blade.
 Clean the saw blade flanges, then mount the new saw blade onto the output spindle and
against the inner flange.
 Make sure the saw teeth and arrow on the blade is to be the same direction as the arrow
on the lower guard.
 Reinstall the outer flange, and tighten the blade clamp bolt.
 Make sure that the saw blade runs freely by turning the blade by hand.
Before replacing the saw blade always unplug the tool.
8.2 Adjusting the depth of cut (Fig. 2)
The depth of cut is infinitely adjustable. A clean cut is achieved with the saw blade protruding
from the material by approx. 3 mm.
 Loosen the lock lever for depth adjustment (5).
 Hold the base plate (10) flat against the edge of the work piece and lift the body of the saw
until the blade is at the right depth determined by the depth gauge (4) (align the scale
line).
 Tighten the lock lever for depth adjustment.