Powerplus POWX052 CIRCULAR SAW 1400W 185MM EN - Manual (Page 7)

POWX052
EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
8.4 Mounting the parallel fence (fig. A)
The parallel fence allows sawing parallel to an edge at a maximum distance of 10 cm.
 Loosen the adjusting screw (12).
 Insert the parallel fence into the saw base (9) as shown in the illustration.
 Set the parallel fence to the required distance.
 Tighten the adjusting screw.
9 OPERATION
9.1 Instructions for use
 Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
 Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
 Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
 For straight cuts along a drawn line use the marking for straight cuts .
 For bevel cuts along a drawn line use the marking for bevel cuts (11).
9.2 Switching on and off (fig. A)
 To switch the tool on, keep the lock-off button (2) depressed and press the on/off switch
(1).
 To switch the tool off, release the on/off switch.
9.3 Dust extraction (fig. A)
A vacuum cleaner can be connected to the dust extraction connector, either directly to the
connector or using an adapter.
 If necessary, connect an adapter to the connector (3).
 Preferably use a vacuum cleaner for industrial use.
9.4 laser beam
The laser beam is used for projection of the cut on the workpiece.
Switch the laser (14) on by means of the laser on/off switch (13)
 Place the machine on the workpiece with the saw marking above the start of the cutting
line.
 Check that the laser line aligns with the cutting line as marked on the workpiece.
 Switch on the machine.

Follow the “instructions for use” to perform a cut.
 After use , switch off the laser.
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.