Powerplus POWX0052 DRILL/SCREWDRIVER 14,4V 2BATT EN - Manual (Page 7)

POWX0052 EN
Copyright © 2015 VARO P a g e | 7 www.varo.com
1. Cordless drill
2. Battery pack
3. Release button
9.2 Charging
9.2.1 Slow charging (3-5h) (refer to technical data for model)
 Put the battery pack in the charger stand. Make sure it is placed correctly ( + and - )
 Insert the connector plug into the charger
 Plug in the socket-outlet( 230V~ )
 When the indicator light starts burning this means the battery pack is now being charged.
Normally it will take 3-5 hours to fully charge the battery. The indicator light will keep
burning, even after the battery is fully charged!
 Unplug the plug after charging
Caution
 Fully charge battery before first use. The battery will reach full capacity after being
charged and discharged several times
 Avoid short periods of charging. Only charge battery pack when fully empty.
 Adaptor, charger and battery pack will be warm when charging. This is normal.
9.3 Inserting drill bits / screwdriver bits
 To insert a drill bit / screwdriver bit, hold the back section of the chuck and rotate the front
section of the chuck
 Insert the drill bit / screwdriver bit into the chuck ( as far as possible )
 For screwdriver bits use an adaptor
 Select the correct screwdriver bit to avoid damaging the screw
 Firmly tighten the chuck by hand and check if the drill bit / screwdriver bit is seated firmly
in the chuck
1. Front section of chuck
2. Back section of chuck