Powerplus POWX0052 DRILL/SCREWDRIVER 14,4V 2BATT EN - Manual (Page 5)

POWX0052 EN
Copyright © 2015 VARO P a g e | 5 www.varo.com
5.4 Power tool use and care
 Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
 Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
 Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tools operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
 Use the power tool, accessories and tool bits etc. in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could result in a hazardous situation.
 Use clamps or a vice to hold the workpiece. It is safer and it frees both hands to operate
the tool.
5.5 Service
 Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 DRILL SAFETY WARNINGS:
 Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
 Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury.
 Hold power tool by insulated gripping surfaces, when performing an operation where the
cutting accessory may contact hidden wiring. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live" and could give the operator an
electric shock.
7 SCREWDRIVER SAFETY WARNING:
 – Hold power tool by insulated gripping surfaces, when performing an operation where the
fastener may contact hidden wiring.
Fasteners contacting a "live" wire may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
8 SPECIAL SAFETY INSTRUCTIONS FOR BATTERY PACK AND
CHARGER
If under extreme conditions any electrolyte should escape from the battery, it's
essential to avoid contact with skin. If electrolyte does come into contact with your skin,
rinse it off with water. In the event of electrolyte contact with your eyes, it's essential to
consult a doctor.
 This appliance is not intended for use by persons(including children)with reduced physical,
sensory or mental capacities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible
for their by person responsible for their safety.
 Children should be supervised to ensure that they do not play with the appliance.