Powerplus POW8130 MITRE SAW 1500W 210MM EN - Manual (Page 9)

POW8130 EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
 Take the blade (5) off the inner flange and pull out downwards.
 Mount the new saw blade in reverse order and fasten.
 Important! The cutting bevel of the teeth, i.e. the
 direction of rotation of the saw blade, has to conform with the direction of the arrow
marked on the housing.
 Clean the saw blade flanges thoroughly before mounting the saw blade.
 Reattach the movable blade guard (6) in reverse order.
 Before using the saw again, check that the safety devices are in good working order.
 Important: Every time that you change the saw blade, check to see that it spins freely in
the groove of the turntable in both perpendicular and 45° angle settings.
12 LASER FUNCTION (FIG. 12)
You can switch the laser ON and OFF with the switch (a).
The laser (35) directs a beam onto the work-piece.
Extremely precise cuts can be made using the laser function.
13 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
13.1 Maintenance
 Keep the ventilation slots of the tool clean to prevent overheating of the engine.
 Remove dust and dirt regularly from the machine. Cleaning is best done with compressed
air or a rag.
 Re-lubricate all moving parts in regular intervals.
 Never use caustic agents to clean plastic parts.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
14 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).