Powerplus POW8130 MITRE SAW 1500W 210MM EN - Manual (Page 7)

POW8130 EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
8 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES
 When replacing batteries, always replace the complete set. Do not mix old batteries with
new ones.
 Prevent removed batteries from short circuiting.
 Do not store batteries where the temperature may rise above 50 °C, e.g. in a car which
has been parked in the sun.
 Do not burn batteries.
 Never attempt to open batteries.
 In case of battery leakage, carefully remove the liquid using a cloth. Avoid skin or eye
contact. Do not swallow. In case of skin or eye contact, rinse abundantly for 10 minutes
with clean water and consult a physician.
9 ASSEMBLY
9.1 Setting up the saw (Fig. 1 / 3/12)
 Insert the two workpiece support clips (12) in the mounts (21) provided on the side of the
tool and fasten them in place with thumb screws (22).
 Insert the clamping device (19) into one of the two mounts (20) provided on the top of stop
rail and fasten in place with the thumb screw (33).
 Screw the additional stability bar (32) to the back of the machine.
9.2 Adjusting the saw (Fig. 1/2)
 The rotary table (8) has latching positions at 0°, 15°, 22.5°, 30° and 45°. You can adjust
the angle by moving the table to the left or to the right using the black handle.
 While pressing down lightly on the machine head (4), pull the lock pin (16) out of the motor
holder to disengage the saw from its bottom working position.
 Swing up the machine head until the retaining hook latches home.
 By loosening the lock screw (12), the machine head (4) can be angled to the left up to 45°.
 Check that the voltage marked on the rating plate is the same as your mains voltage and
connect up the machine.
9.3 90° cross-cuts and 0° rotary table (Fig. 1)
 To turn the machine on, simultaneously press the main switch (3) and locking button (30).
 Important! Place the material you want to saw flat on the machine surface and secure with
the clamping device (19) so that the material cannot move while you are cutting.
 After switching on the saw, wait for the blade (5) to reach its maximum speed.
 Press the release lever (1) sideways and, using the handle (2), apply steady and light
downward pressure to move the machine head through the workpiece.
 When the cut is completed, return the machine to
 its top parking position and let go of the On/Off
 switch.
Caution! A return spring causes the machine head to rise automatically at the end of the cut.
Do not let go of the handle (2) as soon as the cut is completed but steady the machine head
and allow it to rise slowly.
9.4 Precision adjustment of the stop for 90° cross-cuts (Fig. 4/5)
 Lower the machine head (4) and fix with the lock pin (16).
 Slacken the tightening screw (12).
 Place the stop angle (A) between the saw blade (5) and the rotary table (8).
 Slacken the counter nut (23) and adjust the setting screw (24) until the angle between the
saw blade (5) and the rotary table (8) equals 90°.
 Re-tighten the counter nut (23) to fix the machine in this setting.