Powerplus POW5535 COMPRESSOR 1.5HP +7PCS KIT EN - Manual (Page 9)

POW5535
EN
Copyright © 2011 VARO P a g e | 9 www.varo.com
§ The width of the spray pattern can be adjusted by rotating the adjustment knob F (fig. 3)
§ The volume of paint/material sprayed can be adjusted by reducing or increasing the stroke
of trigger G, turning the adjustment knob H (fig. 3)
§ To operate the paint spray gun, pull trigger G (fig. 3). Pulling the trigger half way,
compressed air only is passed through nozzle E. This facility is useful when you have
finished painting and want to clean the gun. Pulling trigger G so that it is fully engaged,
material is introduced in the gun and spray painting can begin
§ During spraying, release the vent valve I of paint cup A (fig. 4)
9.2 Tips for using the paint spray gun
Before using the spray gun, practice on a test material in order to establish the correct pattern
of spray and the correct quantity of material to be applied. Never exceed the recommended air
pressure The paint or material to be sprayed may require thinning. The thinning fluid and
dilution formula should be obtained from the Manufacturer. Paint/material that is too thick may
block the nozzle on the spray gun, preventing use. When filling the paint cup with
paint/material, maintain the spray gun in a vertical position to avoid spillage.
9.3 Maintenance
§ After use, the paint spray gun must be cleaned thoroughly.
§ After disposing of any material not used, add a small quantity of paint thinner to paint cup
A and use the spray paint gun again as during spraying, fully pressing trigger G and
complying with the same safety precautions. This operation permits initial cleaning of the
fluid ducts.
§ To clean, unscrew nozzle D and ring E (fig. 5).
§ Disassemble the spraying needle by unscrewing knob H and extracting spring L and
needle M (fig. 6).
§ Lubricate the socket of the spraying needle N at regular intervals (fig. 6).
§ Thoroughly clean these items with a suitable product.
§ Also clean the fluid passage through the socket of paint cup A (fig. 1).
10 INFLATION GUN
For inflating tires, rubber dinghies, air beds, footballs and other objects
PRESSURE LEVEL: 3
Do not direct the jet of compressed air towards the people or animals.
Never inflate the objects above the recommended inflation pressure as this
may be dangerous and cause damage and injuries
10.1 Use of the inflation gun
§ Connect the inflation gun to the compressor, as explained in chapter 2 “CONNECTING
THE ACCESSORIES TO YOUR AIR COMPRESSOR”
§ When inflating car tires or certain bicycle tires, it is not necessary to insert any of the
adapters (fig. 2). Press tab A and connect the hose to the tire pushing the fitting on the
valve (fig. 3) and then releasing the tab.
§ Regulate working pressure to the value indicated for this accessory
§ Inflate the tire pressing lever B until the inflation pressure required, indicated on gauge C,
is reached (figures 1-4). In the case of over-inflation, press button D to reduce inflation
pressure (figures 1-4)