Powerplus POW5535 COMPRESSOR 1.5HP +7PCS KIT EN - Manual (Page 7)

POW5535
EN
Copyright © 2011 VARO P a g e | 7 www.varo.com
7 ASSEMBLY AND STARTING
Important! You must fully assemble the appliance before using it for the
first time.
7.1 Fitting the wheels (3)
Fit the supplied wheels as shown in Fig. 3.
7.2 Fitting the supporting foot (4)
Fit the supplied rubber stopper as shown in Fig. 4.
7.3 Voltage
The compressor is equipped with a mains cable with shock-proof plug. This can be connected
to any 230V ~ 50Hz shock-proof socket which is protected by a 16 A fuse. Before you use the
machine, make sure that the mains voltage complies with the specifications on the rating plate.
Long supply cables, extensions, cable reels etc. cause a drop in voltage and can impede
motor start-up. In the case of low temperatures below +5°C, motor start-up is jeopardized as a
result of stiffness.
7.4 On/Off switch (8)
To switch on the equipment set the On/Off switch (8) to position 1.
Move the On/Off switch (8) to position 0 to switch off the equipment.
7.5 Adjusting the pressure: (Fig. 1)
You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7).
The set pressure can be taken from the quicklock coupling (5).
7.6 Setting the pressure switch
The pressure switch is set at the factory.
Switch-on pressure 6 bar
Switch-off pressure 8 bar
8 CLEANING AND MAINTENANCE
Important! Pull the power plug before doing any cleaning and maintenance
work on the appliance.
Important! Wait until the compressor has completely cooled down. Risk of
burns!
Important! Always depressurize the tank before carrying out any cleaning
and maintenance work.
8.1 Cleaning
§ Keep the safety devices free of dirt and dust as far as possible. Wipe the equipment with a
clean cloth or blow it with compressed air at low pressure.
§ We recommend that you clean the appliance immediately after you use it.
§ Clean the appliance regularly with a damp cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to the plastic parts in the appliance. Ensure
that no water can get into the interior of the appliance.
§ You must disconnect the hose and any spraying tools from the compressor before
cleaning. Do not clean the compressor with water, solvents or the like.