Powerplus POW5535 COMPRESSOR 1.5HP +7PCS KIT EN - Manual (Page 11)

POW5535
EN
Copyright © 2011 VARO P a g e | 11 www.varo.com
13 POSSIBLE FAULTS AND RELATED PERMITTED REMEDIES
Fault Cause Remedy
The compressor
does not start
1. No supply voltage 1. Check the supply voltage, the
power plug and the socket-outlet.
2. Insufficient supply voltage 2. Make sure that the extension
cable is not too long. Use an
extension cable with large enough
wires.
3. Outside temperature is too
low 3. Never operate with an outside
temperature of below +5°C.
4. Motor is overheated 4. Allow the motor to cool down. If
necessary, remedy the cause of the
overheating.
The compressor
starts but there is
no pressure
1. Leak in the non-return
valve 1. Replace the non-return valve
2. The seals are damaged. 2. Check the seals and have any
damaged seals replaced by a service
center
3. The drainage screw for
condensation
water (11)
leaks.
3. Tighten the screw by hand. Check
the seal on the screw and replace if
necessary.
The compressor
starts, pressure is
shown
on the
pressure gauge,
but the tools do
not start.
1. Loose hose connections 1. Check the compressed air hose
and tools and replace if necessary.
2. Leak in a quick-lock
coupling 2. Check the quick-lock coupling and
replace if necessary.
3. Insufficient pressure set on
the pressure regulator. 3. Open the pressure regulator
further.
14 WARRANTY
§ This product is warranted as provided by law for a 24 -month period effective from the
date of purchase by the first user.
§ This warranty covers all material or production flaws. It does not include defective parts
subject to normal wear & tear such as bearings, brushes, cables, and plugs, or
accessories such as drills, drill bits, saw blades, etc. ; damage or defects resulting from
maltreatment, accidents or alterations; nor the cost of transportation.
§ This warranty covers all material or production flaws, excluding batteries, chargers,
defective parts subject to normal wear and tear such as, in particular, bearings, brushes,
cables, plugs… Accessories such as drills, drill bits, saw blades etc. also do not fall under
this warranty.
§ Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
§ We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.
§ Repairs may only be carried out by an authorised customer service centre for Powerplus
tools.
§ You can always obtain more information at the number 00 32 3 292 92 90.
§ Any transportation costs shall always be borne by the customer, unless agreed otherwise
in writing.
§ At the same time, no claim can be made on the warranty if the damage of the device is the
result of negligent maintenance or overload.