Powerplus POW5535 COMPRESSOR 1.5HP +7PCS KIT EN - Manual (Page 8)

POW5535
EN
Copyright © 2011 VARO P a g e | 8 www.varo.com
8.2 Condensation water
The condensation water must be drained off each day by opening the drain valve (11) (on the
floor of the pressure vessel).
Important! The condensation water from the pressure vessel will contain
residual oil. Dispose of the condensation water in an environmentally
compatible manner at the appropriate collection point.
8.3 Safety valve (10)
The safety valve has been set for the highest permitted pressure of the pressure vessel. It is
prohibited to adjust the safety valve or remove its seal. Actuate the safety valve from time to
time to ensure that it works when required. Pull the ring with sufficient force until you can hear
the compressed air being released. Then release the ring again.
8.4 Storage
I mportant! Pull the mains plug out of the socket and ventilate the appliance
and all connected pneumatic tools. Switch off the compressor and make
sure that it is secured in such a way that it cannot be started up again by
any unauthorized person.
Important! Store the compressor only in a dry location which is not
accessible to unauthorized persons. Always store upright, never tilted!
9 PAINT SPRAY GUN GB
For spraying of paint, stain and lacquers
PRESSURE LEVEL: 3
Always wear a protective mask, goggles and protective gloves when spray
painting. Spray paint only in a well-ventilated area. The accessory must
always be used in accordance with the Manufacturer’s instructions and
safety regulations.
Some paints and other materials are combustible when sprayed and should
not therefore be sprayed close to flames or any heat source or any areas
where sparks may occur. If in doubt about the safe use of materials, please
consult the Manufacturer before use
9.1 Using the spray gun
§ Connect the paint spray gun to the compressor as explained in chapter 2 “CONNECTING
THE ACCESSORIES TO YOUR AIR COMPRESSOR”
§ Adjust working pressure to the value indicated for this accessory
§ Position the paint cup A and screw it into the socket B (fig. 1). Make sure that the paint
cup is securely screwed into the socket, otherwise paint may leak during use
§ Remove the lid C of paint cup A (fig. 2)
§ The paint or the material (max. 0.5 lt.) to be sprayed can now be inserted in paint cup A
§ Replace paint cup lid C by securely pushing this into paint cup A (fig. 2)
§ The spray pattern (horizontal or vertical spraying) can be adjusted by loosening ring D and
turning nozzle E and then retightening ring D (fig. 3)