Cutting and sanding (fig. a & b), Deburring (fig. a & b), Drilling (fig. a & b) – Powerplus POW1820 MULTITOOL 135W EN User Manual

Page 7: Routing (fig. a & b), Engraving (fig. a & b), Grinding and sanding (fig. a & b), Replacing a sanding band (fig. b), Using the grinding stone (fig. b), Using the standard (fig. e), Pow1820

POW1820

P a g e

| 7

www.varo.com

7.7

Cutting and sanding (fig. A & B)

A cutting disc is used for cutting metal, plastic, wooden and stone workpieces. A sanding disc
is used for sanding wooden and plastic workpieces. A mandrel is used for mounting a cutting
disc or sanding disc.
 Place the mandrel (15) in the collet nut (6).
 Loosen the screw on the mandrel.
 Place a cutting disc (21) or sanding disc (20) on the screw.
 Place the screw on the mandrel and tighten it.

7.8

Deburring (fig. A & B)

A grinding disc for deburring is used for removing burrs from metal workpieces. A mandrel is
used for mounting a grinding disc for deburring.
 Place the mandrel (15) in the collet nut (6).
 Loosen the screw on the mandrel.
 Place a grinding disc for deburring (22) on the screw.
 Place the screw on the mandrel and tighten it.

7.9

Drilling (fig. A & B)

A drill bit is used to drill holes in plastic, wooden and stone workpieces.
 Place a drill bit (10) in the collet nut (6).

7.10

Routing (fig. A & B)

A router bit is used for grooving and for routing figures in plastic, wooden and metal
workpieces.
 Place a router bit (13) in the collet nut (6).

7.11

Engraving (fig. A & B)

An engraving needle is used for engraving figures in metal workpieces.
 Place an engraving needle (16) in the collet nut (6).

7.12

Grinding and sanding (fig. A & B)

A grinding stone is used for grinding metal, plastic, wooden and stone workpieces. A sanding
band is used for sanding wooden and plastic workpieces.
 Place a grinding stone (11) or sanding band with mandrel (12) in the collet nut (6).

7.13

Replacing a sanding band (fig. B)

A sanding band must be replaced when showing signs of wear.
 Remove the old sanding band from the mandrel.
 Place the new sanding band (18) on the mandrel.

7.14

Using the grinding stone (fig. B)

 Use the grinding stone for removing burrs and other irregularities on the workpiece.

7.15

Using the standard (fig. E)

The standard allows the machine to be hung when using the flexible spindle.
 Mount the base (23) to the edge of the worktop.
 Turn the telescope arm (24) into the base.
 Bring the standard to the desired height by sliding the telescope bars (25) in or out as

required.

 Tighten the telescope bars one by one.
 Mount the flexible spindle to the machine.
 Hang the machine to the standard as shown.