Using the flexible spindle (fig. c1 - c4 & d), Replacing the collet (fig. a & b), Switching on and off (fig. a) – Powerplus POW1820 MULTITOOL 135W EN User Manual

Page 6: Adjusting the speed (fig. a), Polishing (fig. a & b)

POW1820

P a g e

| 6

www.varo.com

 In order to remove the accessory, proceed in reverse order.

Before mounting an accessory, always unplug the tool.

7.2

Using the flexible spindle (fig. C1 - C4 & D)

To mount the flexible spindle, proceed as follows:
 Keep the spindle lock button (4) depressed.
 Loosen the collet nut (6).
 Successively remove the collet nut (6) and the collar (5).
 Remove the collet nut from the flexible spindle and fit it onto the tool.
 Insert the end of the flexible spindle into the collet nut.
 Tighten the collet nut.
 Release the spindle lock button.
 Fit the collar of the flexible spindle onto the tool. Tighten the collar.
 Fit the collet nut (6) onto the flexible spindle.
To mount an accessory, proceed as follows:
 Position the key (8) in the recess to fix the collet.
 Loosen the collet nut (6).
 Insert the shaft of the accessory into the collet.
 Tighten the collet nut.
 Remove the key.
 In order to remove the accessory, proceed in reverse order.

Before mounting an accessory, always unplug the tool.

7.3

Replacing the collet (fig. A & B)

 Keep the spindle lock button (4) depressed.
 Use the spanner (7) to slacken the collet nut (6).
 Remove the collet nut and the old collet (9).
 Place the new collet.
 Replace the collet nut.
 Release the spindle lock button.

Always unplug the tool before replacing the collet.

7.4

Switching on and off (fig. A)



To switch the machine on, set the on/off switch (1) to ‘I’.



To switch the machine off, set the on/off switch (1) to ‘0’.

7.5

Adjusting the speed (fig. A)

This machine has been fitted with an adjusting wheel (2) for the maximum speed.
 Turn the adjusting wheel (2) as indicated on switch (1) to set the maximum speed.
 Choose a low speed for working wood and plastics.
 Also choose a low speed for polishing.

7.6

Polishing (fig. A & B)

A polishing wheel is used for polishing metal and plastic workpieces.
A mandrel is used for mounting a polishing wheel.
 Place the mandrel (14) in the collet nut (6).
 Place a polishing wheel (19) on the screw.