Powerplus POWXQ5390 CUT-OFF SAW FOR METAL 2000W 355MM EN - Manual (Page 7)

POWXQ5390 EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
medical implants consult their doctor and the manufacturers of the implants before
operating this device.
8 TRANSPORT AND START OF OPERATION
8.1 Transport and set-up

The machine must be set up indoors. Upon installation, the workplace must provide
satisfactory conditions for the proper performance of technical work.
 The installation surface must be sufficiently level and load-bearing. If required, the
machine can be fastened down to the installation surface.
 Due to packaging technical reasons the machine comes not fully assembled.
8.2 Assembly
 If you discover transport damage while unpacking the machine inform your dealer
immediately. Do not use the device!

Please dispose of the packaging in an environmentally-friendly way.

Remove the anti-corrosive grease from the saw table using a mild solvent.
8.3 Assembly of clamping jig handle (J) (Fig. 2)
8.4 Release of the saw head
The machine comes fitted with a locked saw head as standard. The lock bolt of the saw head
(Q) can be removed. Let the saw head slide slowly upward. (Fig. 3)
When transporting the machine the saw head must be locked in place again.
8.5 Key storage
Put the supplied key (T) in the holder on the rear of the saw. (Fig. 4)
8.6 Electrical connection
 The mains power supply and the extension cable used must meet the stipulated
regulations.
 The mains supply and the frequency must agree with the data provided on the machine
rating plate.
 The device must be protected by a 10 A fuse.
 Only use a mains cable with the designation H07RN-F.
 Connections and repair of electrical equipment may only be carried out by qualified
electricians.
8.7 Start of operation
Press switch (A) on D-handle (B) to start the device: As soon as you release the switch the
machine will shut off.
9 OPERATING THE MACHINE
9.1 Correct working position:
Stand in front of the machine in the direction of the cut.
9.2 Handling the work piece:
 The work piece to be cut must be firmly held in the clamping jig, so that it cannot move
during the cutting process.

Always secure the work piece between angle plate (G) and clamping jig pressure plate
(H). ( Fig. 5)

Do not cut undersized work pieces.

Support long work pieces with roller blocks.

Large, round or irregularly shaped work pieces must have additional clamping
arrangements. Use G-clamps and blocks to firmly hold the work piece in place.