Powerplus POWXQ5390 CUT-OFF SAW FOR METAL 2000W 355MM EN - Manual (Page 9)

POWXQ5390 EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
 Replace the key in the holder.

Plug in the mains plug.

Let the saw run and check whether the cut-off wheel is in good condition. To test a new
wheel let the saw run for 3 minutes.
Always stand to the side of the saw when starting it up.
10.2 Adjustment of cutting-depth stop

Depth stop (P) must be set as the diameter of the cut-off wheel decreases through use.
(Fig. 8)

This is to avoid cutting the work surface.
11 TECHNICAL DATA
Mains supply 230-240 V ~ 50 Hz
Rated input 2000 W
Idling speed 3500 min-1
Cut-off wheel Ø355 x Ø25.4 x 3.0mm
Miter angle left/right 30°/45°
Current protector 10 A
Connection cable 3 x 1.0 mm²
Weight 20 kg
Max. Cutting capacity 90° 45°
Ø100mm Ø80mm
100x100mm 60x60mm
120x95mm 85x60mm
100x100mm 60x60mm
12 SOUND EMISSION
Noise emission values measured according to relevant standard. (k=3)
Acoustic pressure level LpA
100 dB(A)
Acoustic power level LwA 116 dB(A)
ATTENTION ! The sound power pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
aw (Vibration): 3.0 m/s² K = 1.5 m/s²