Powerplus POWXQ5390 CUT-OFF SAW FOR METAL 2000W 355MM EN - Manual (Page 10)

POWXQ5390 EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
13 CLEANING AND MAINTENANCE
Only perform cleaning, maintenance and repair work after first unplugging
the mains plug.
 Secure the machine against unintentional start-up before undertaking all such work. Pull
out the mains plug!
 Connections and repair of electrical equipment may only be carried out by qualified
electricians.

All protective guards etc. must be immediately refitted after maintenance, cleaning or
repair work.
 Replace damaged protective guards at once.
13.1 Cleaning
 Clean the machine housing regularly with a soft cloth, preferably after each use. Keep the
ventilation slots clear of dust and dirt.
 Remove stubborn dirt with a soft cloth moistened with soapy water.
 Do not use solvents such as petroleum, alcohol, ammonia etc. Such agents damage the
plastic parts.

Cut-off wheels: Only use flawless cut-off wheels.
13.2 Replacing the carbon brushes (Fig. 9)
 Disconnect the mains supply by pulling out the mains plug.
 Inspect the brushes after 50 service hours.
 These must be replaced if they have been worn right down to 6 mm.
14 TROUBLESHOOTING
The motor does not
start No power. Check power supply, cable
and fuse.
Motor, switch or cable defective. Contact a qualified electrician.
Carbon brushes worn out. Replace carbon brushes.
Machine vibrates
strongly. Uneven machine surface. Provide an even surface.
Damaged cut-off wheel. Replace wheel at once.
Cutting angle not 90° Work piece stop set wrong.
Poor sawing pattern Worn cut-off wheel.
Various metal particles stuck to cut-off wheel.
Work piece not suitable for cutting.
Feed pressure too high. Never force cutting process.
15 WARRANTY

This product is warranted for a 5-year period effective from the date of purchase by the
first user.
 This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.
 Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
 We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.