Powerplus POWXQ5220 HAMMER DRILL 520W EN - Manual (Page 7)

POWXQ5220 EN
Copyright © 2010 VARO P a g e | 7 www.varo.com
9 OPERATING THE MACHINE
9.1 Switching on and off
 Switching on: Press the on- off switch 10
 Switching off: Release the on- off switch 10
9.2 Overload clutch
If the drill bit becomes jammed or caught, the drive to the drill spindle is interrupted.
Because of the forces that occur as a result, always hold the machine with both hands and
take a secure stand.
The machine should be used only with an auxiliary handle.
9.3 Operating modes
The tool can be set at following operation modes by turning the front and rear mode selectors
to different positions
When switching operation modes, please trigger ON/OFF swich slightly.
9.3.1 Hammer drill mode
The tool produces an impact force while turning, suitable for masonry drilling, such as drilling
on concrete and bricks.
Front mode selector Rear mode selector
9.3.2 Chisel mode
The tool produces only impact force, suitable for chiselling on concrete and bricks.
Front mode selector Rear mode selector
9.3.3 Drill mode
The tool only has turning action, suitable for drilling on metal and non – metal objects.
Front mode selector Rear mode selector