Powerplus POWAIR0106 PAINT SPRAY GUN 750CC 750CC EN - Manual (Page 8)

POWAIR0105-106 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
Symptom Problems Solution
Fluid leaking from packing nut Packing nut loose
Packing worn or dry Tighten, but do not restrict
needle
Replace or lubricate (non-
silicone oil)
Excessive overspray Too high atomization
pressure
Too far from work
surface
Improper stroking
(arcing, gun motion
too fast) Reduce pressure
Adjust to proper distance
Move at moderate pace,
parallel to surface.
Will not spray No pressure at gun
Fluid control not open
enough
Fluid too heavy Check air lines
Open fluid control
Thin fluid or change to
pressure feed system.
10 ENVIRONMENT
Should your machine need replacement after extended use, do not put it in the domestic
waste but dispose of it in an environmentally safe way.