Adjustment, Pattern adjustment, Fluid (paint) adjustment – Powerplus POWAIR0106 PAINT SPRAY GUN 750CC 750CC EN User Manual
Page 4: Operation
POWAIR0105-106
EN
Copyright © 2014 VARO
P a g e
| 4
www.varo.com
6.
Set up a piece of cardboard or other scrap material to use as a target and adjust for
best spray pattern.
WARNING Never aim or spray at yourself or anybody else which would
cause serious injury.
7.
Test the consistency of the material by making a few strokes on a cardboard target. If
material still appears too thick, add a small amount of thinner. THIN WITH CARE! Do
not exceed paint manufacturer
’s thinning recommendations.
5.2 Adjustment
The desired pattern, volume of fluid output and fine atomization can easily be obtained by
regulating the Pattern Adjusting Knob,Fluid (PAINT) Adjusting Knob.
Decrease:
Pattern:
Increase:
Decrease:
Fluid:
Increase:
5.2.1
Pattern adjustment:
Turning pattern adjusting knob to the right till the end will make spray pattern round, or
turning left will make spray pattern ellipse.
5.2.2
Fluid (paint) adjustment:
Turning the paint adjusting knob clockwise will decrease the volume of fluid output and
counter-clockwise will increase fluid output.
5.2.3
Operation
1.
Begin spraying. Always keep the gun at right angles to the work .