Powerplus POWAIR0106 PAINT SPRAY GUN 750CC 750CC EN - Manual (Page 7)

POWAIR0105-106 EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
9 TROUBLE SHOOTING
Symptom Problems Solution
Fluttering or spitting Material level tool low.
Container tipped too
far.
Loose fluid inlet
connection.
Loose or damaged
fluid tip/seat.
Dry or loose fluid
needle packing nut.
Air vent clogged Add material into container.
Hold more upright.
Tighten.
Adjust or replace.
Lubricate and or tighten.
Clear vent hole.
Pattern is arc. Worn or loose Fluid
nozzle.
Material build up on
Air cap. Tighten or replace Fluid
nozzle.
Remove obstructions from
holes,
but don’t use metal
objects to clean it.
Pattern is not Evenly spread. Material build up on
Air cap.
Fluid nozzle dirty or
worn. Clean or replace Air cap.
Clean or replace Fluid
nozzle.
The center of Pattern too
narrow. Material too thin or not
enough.
Atomization air
pressure too high. Regulate material viscosity.
Reduce air pressure.
Pattern width of fan-sharp is
not enough. Material too thick.
Atomization air
pressure too low. Regulate material viscosity.
Increase air pressure.
Air leaking from air cap
without pulling trigger Sticking air valve stem
Contaminate on air
valve or seat
Worn or damaged air
valve or seat
Broken air valve
spring
Bent valve stem Lubricate
Clean
Replace
Replace
Replace