Powerplus POWAIR0109 PAINT SPRAY GUN 600CC EN - Manual (Page 3)

POWAIR0109 EN
Copyright © 2014 VARO P a g e | 3 www.varo.com
4 SAFETY INSTRUCTIONS
4.1 Fire or explosion hazard

Fluid and solvents can be highly flammable or combustible.

Use in well-ventilated spray booth.

Avoid any ignition sources such as smoking, open flames, slsctrical hazard,etc.
 Never use HALOGENATED HYDROCARBON SOLVENTS
(1.1.1TRICHLORINE,ETHYL CHLORIDE, etc.) Which can chemically react with
aluminium and zinc parts and cause an explosion. Be sure that all fluids and
solvents used are chemically compatible with aluminium and zinc parts.
 To reduce the risk of static sparking, grounding continuity to the spray equipment ane
object being sprayed must be maintained.
4.2 Misuse hazard
 NEVER point gun in the direction of human body.
 NEVER exceed the maximum safe working pressure of the epuipment.
 ALWAYS release air and fluid pressures before cleaning ,disassembling or servicing.
 For emergency stop and prevention of unintended operation, a ball valve installation
near the gun to stop air supply is recommended .
4.3 Hazard created while coating materials are atomized and sprayed
 Toxic vapours produced by spraying certain materials can create intoxication and
serious damage to health.

-Use the gun in well-ventilated areas.

-Always wear protective eyewear, gloves, respirator, etc.to prevent the toxic vapour
hazard, solvents and paint from coming into contact with your eyes or skin.
 Noise level mentioned in main specifications was measured at 1.0m behind the tip of
the gun, 1.6m height from floor.

-Wear earplugs if required.
4.4 Other hazards

NEVER modify this product for any applications.

NEVER enter working areas of robots, reciprocators, conveyors, etc, unless
machines are switched off .
 NEVER spray foods or chemicals through the spray gun.