Casio YA-S10 Setup Guide - Manual (Page 13)

Getting Ready
E-12
The terminals on the sides and back of the Control Box connect to the power source and various devices
as described below.
Control Box Side: Connect one or two projectors.
When connecting the Control Box to a projector using a supplied HDMI cable, connect the plug of the
cable that is nearest the ferrite core to the HDMI port of the Control Box.
Important! Important! Important!
z If you are connecting only a single projector, use the OUTPUT A group terminals.
z If you are connecting two projectors, the projector connected to the OUTPUT A group terminals
is referred to as “Projector A”, while the projector connected to the OUTPUT B group terminals
is referred to as “Projector B”. Later when configuring settings and making adjustments, we will
need to distinguish between Projector A and Projector B.
Control Box Back: Connect the AC adapter and the input source device.
Wiring
*1 To control the Projector System from an external device over a LAN, use a commercially available
LAN cable to connect this terminal to the LAN terminal of the external device.
*2 To control the Projector System from an external device over an RS-232C connection, use a
commercially available serial cable (cross) to connect this port to the serial port of the external
device.
OUTPUT A Group OUTPUT B Group
Use a commercially available
RS-232C cable to connect.
Use a supplied HDMI cable to
connect.
Connect to the HDMI port of the second projector.
Connect to the RS-232C port of the second projector.
Connect to the HDMI port of the first projector.
Connect to the RS-232C port of the first projector.
Ferrite core
Connect the supplied AC adapter and plug it into a power outlet.
*1 *2
Use a commercially available HDMI cable to connect to the HDMI output port of an image
source device.
Use a commercially available cable to connect to the RGB output terminal or to
the component output terminal of an image source device.