Casio CTK-3400 - Manual (Page 13)

English
Controlling the Keyboard Sounds
EN-11
3.
Select the second tone you want to use.
Press bp (TONE) and then use bo (–/+) to select the
tone you want.
4.
Play something on the keyboard.
Both tones sound at the same time.
5.
Holding down 3 (FUNCTION) and pressing 7
(LAYER) again will unlayer the tones for output
of a single tone.
• Each press of 7 (LAYER) while 3 (FUNCTION) is
held down will toggle between layered (two tones) and
unlayered (one tone).
You can use the procedure below to assign different tones to
the right range and left range of the keyboard, so it sounds
like you are playing an ensemble between two instruments.
1.
Select the tone for the right side range (page
EN-10).
Press bp (TONE) and then use bo (–/+) to select the
tone you want.
2.
While holding down 3 (FUNCTION), press 8
(SPLIT).
3.
Select the tone for the left side range.
Press bp (TONE) and then use bo (–/+) to select the
tone you want.
4.
Play something on the keyboard.
This will sound the tones assigned to the left and right
side ranges of the keyboard.
• The mark above the graphic keyboard on the screen
indicates the initial default split point setting.
5.
Holding down 3 (FUNCTION) and pressing 8
(SPLIT) again will unsplit the tones for output of
a single tone.
• Each press of 8 (SPLIT) while 3 (FUNCTION) is
held down will toggle between split (two tones) and
unsplit (one tone).
• If you turn on both layer and split, layering will be applied to
the right side range of the keyboard only.
1.
While holding down 3 (FUNCTION), press 8
(SPLIT).
• Keep 3 depressed until the next step is complete.
2.
While holding down 3 (FUNCTION), press the
keyboard key where you want the split point to
be.
The key you press will become the lowest note of the right
side range of the split keyboard.
Example: D08 STRINGS
Splitting the Keyboard between
Two Different Tones
To select the two tones for a split keyboard
Example: F11 FLUTE
Example: B20 VIBRAPHONE 1
S t r i n
g
s
F l u t e
Lights
V i b e s 1
To change the split point
Example: Setting middle C (C4) as the split point.
F3
VIBRAPHONE 1 FLUTE
Split point
C 4
Key name
CTK3400SK_A5_x1a_EN_ES.indd 13 2013/10/09 18:58:25