Casio LK-73 - Manual (Page 11)

Song Memory Function
E-42
Example 2:
To input Gm/C, hold down C and G on the root input
keyboard and press the m key on the chord type input
keyboard.
During step recording, the number buttons are used to
specify the length of each note.
J Note lengths
Š Use number buttons [1] through [6] to specify whole
notes ( ), half notes ( ), quarter notes ( ), eighth notes ( ),
16th notes ( ), and 32nd notes ( ).
Example:
To specify a quarter note ( ), press [3].
J Dots ( ) and triplicates ( )
Š While holding down the [7] (dot) or [9] (triplicate), use
buttons [1] through [6] to input the lengths of the notes.
Example:
To input a dotted eighth notes ( ), hold down [7]
and press [4].
J Ties
Š Press [8] and then input the first and then the second note.
Example:
To input , press [8] and then press [4] (note
length) while holding down [7] (dot). This note will
be tied to the next note you input (16th note in this
example).
J Rest
Š Hold down [0] and then use number buttons [1] through
[9] to specify the length of the rest.
Example:
To input an eighth note rest, hold down [0] and press
[4].
The following describes a number of different variations you
can use when recording to Track 1 using step recording. All
of these variations are based upon the procedure described
under “To record chords to Track 1 using step recording” on
page E-40.
J To start accompaniment with an intro pattern
In step 5, press the INTRO button after the SYNCHRO/
ENDING button.
J To switch to a rhythm variation
In step 6, press the VAR/FILL-IN button immediately before
inputting the chord.
J To insert a fill in
In step 6, press the NORMAL/FILL-IN or VAR/FILL-IN
button at the measure or beat immediately before the chord or
beat where you want to insert the fill in.
J To insert an ending
In step 6, press the SYNCHRO/ENDING button at the
measure or beat immediately before the chord where you
want to insert the ending.
Š The length of the ending depends on the rhythm you are
using. Check the length of the pattern you are using and set
the length of the chord accordingly in step 7. Making the
chord too short in step 7 can result in the ending pattern
being cut off.
J To step record chords without rhythm
After performing steps 1 through 4, you can use the number
buttons to input the length of the specified chord. Skipping
step 5 (not pressing the SYNCHRO/ENDING button) creates
chord without rhythm, so you can input a rest by pressing the
[0] button in step 6 and then specifying the length of the rest
in step 7.
J To add chord accompaniment part way through
rhythm play
In step 6, input all rests from the beginning of the recording
up to the point where you want accompaniment to start.
Next, input the chords.
Specifying the Length of a Note
Track 1 Step Recording Variations
641A-E-044A