EverFocus EDR1600 User Manual

Page 47

Administrator’s Guide and Operating Instructions

the box in front. Basically, the system can detect it automatically,

doesn’t require user to define it. However, the system might

sometimes misjudge due to the ambiguous signal, which mainly

caused be over-length or bad quality cable. In this case, the user can

define it manually to meet the local system.

Main Monitor Sharpness – The slider bar is for adjusting the

sharpness of the images shown on the main monitor screen. To set

the sharpness, click on the slider and drag the mouse, to left is for

sharper images, to right is for less sharp ones.

?????

Software Upgrade –Click on the button, the system will

automatically detect and show the message to inform the user if

there’s a later version software available for downloading. To

upgrade the software, just click on Yes to confirm the downloading.

The system will automatically reboot and upgrade while the

downloading is completed. As the processes have to be done over

internet, please make sure that the system is well connected to the

internet and the communication setting is correct.

???

Factory Setting – Click on the button to revert all the configuration

setting to the default value.

Note : The V 2.0(and later version) software can support Networking for either

30 FPS(NTSC) /25FPS(PAL) or 60FPS(NTSC)/50FPS(PAL) recording

rate models. However, the system requires 128 MB DRAM and LAN card,

please contact the local distributor for system upgrade.