beautypg.com

Technical data, Replacing the lamp, Closing the door – Electrolux 925033685 User Manual

Page 15

background image

Problem

Possible cause

Solution

The appliance has no power.

There is no voltage in the mains

socket.

Connect a different electrical ap-

pliance to the mains socket. Con-

tact a qualified electrician.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the lamp".

As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

CAUTION!

Disconnect the plug from the mains socket.

1. Remove the screw from the lamp cover.

2. Pull outwards the hook of the lamp cov-

er.

3. Remove the lamp cover.

4. Replace the lamp with one of the same

power (the maximum power is shown on

the light bulb cover).

5. Install the lamp cover.

6. Tighten the screw to the lamp cover.

7. Connect the plug to the mains socket.

8. Open the door. Make sure that the light

comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

Technical data

Dimension

Height

1850 mm

Width

595 mm

Depth

632 mm

Rising Time

18 h

The technical information are situated in the rating plate on the internal left side of the

appliance and in the energy label.

1

2

3

Technical data

15