Auriol 2-LD3533-1 - Manual (Page 34)


- 32 -
Stopwatch feature
The stopwatch can measure a duration of up to 60 minutes in 1/10 second
intervals.
Start: Press button A- the 1/10 second hand will start to rotate. The 1/10 second
hand will run during the first minute of the measured time period- after this the
movement will continue counting internally to conserve battery power. The second
and minute hands will continue to run. Press button A again to stop the stopwatch.
The measured time can now be read.
Press button B to move the hands back to the "0" position.
Lap time measurement
Press button A to start the stopwatch- press button B to stop the stopwatch and read
the lap time, the stopwatch will continue to count internally. Press button B again to
show the running stopwatch time. This process can be repeated as often as desired.
Press A to stop the stopwatch and read the stopped time.
Adjusting the stopwatch hands
If the small stopwatch hands are not exactly in the "0" position (12 o'clock position)
they must be adjusted manually. Pull the crown out to the 2
nd stop – repeatedly
press button A (1/10 seconds) or button B (seconds) to move the hands back to the
"0" position. The minute hands of the stopwatch can be adjusted by pressing and
holding B for a longer duration. Press the crown back to the initial position.
Water resistance
Water resistant up to 10 bar. The bar value specifies the atmospheric overpressure
which is applied during testing (DIN 8310).