Auriol Z30237B_C - Manual (Page 34)

34 GB/MT
Switching off the alarm signal
Press any button except the SNOOZE button 20
to stop the alarm signal sounding. You do not
have to reactivate the alarm. It reactivates itself
automatically according to the weekly rhythm.
Note: The alarm signal switches itself off after
2 minutes.
© Displaying the temperature
in °C / °F
The current inside temperature 7 is indicated on
the LCD.
Press the DOWN button 22 to switch between
the Celsius and Fahrenheit temperature scales 7 .
Moon phase (Model B only)
The LCD radio-controlled wall clock shows the current
moon phase
8 in the LC display (Model B only).
It uses the following symbols:
Full moon Waning
gibbous Last quarter Waning
crescent
New moon Waxing
crescent First quarter Waxing
gibbous
© Displaying summertime
Summertime is automatically indicated on the LCD
by the summertime icon
4 . The clock receives
the information as to whether it is summertime or not
from the DCF radio signal.
Note: Reception of the radio signal may be seriously
disrupted in reinforced concrete buildings.
Setting the time zone
Press and keep pressed the DOWN button 22 for
about 2 seconds. The time zone symbol 5
is displayed.
Press and keep pressed the SET button 25 for
about 3 seconds. The hour display flashes.
Press the UP 23 or DOWN button 22 to set
the desired hour value.
Press the SET button 25 to confirm your setting.
Note: Press and keep pressed the DOWN button 22
for about 2 seconds to deactivate the time zone
function.
© Troubleshooting
This appliance has delicate electronic compo-
nents. This means that if it is placed near an
object that transmits radio signals, it could cause
interference. This could be, for example, mobile
telephones, walkie talkies, CB radios, remote
controls and microwaves. If the display indicates
a problem, move such objects away from it.
Electrostatic discharges may cause malfunctions.
In the event of such malfunctions, remove the
batteries briefly and reinsert them.
© Cleaning and Maintenance
½
Under no circumstances should you use liquids
or detergents, as these will damage the device.
˽
The device should only be cleaned on the out-
side with a soft dry cloth.
Operation / Troubleshooting / Cleaning and Maintenance