Curtis SRCD159PL - Manual (Page 8)

Start playback for CDs disc
1. When it is connected to a power supply (refer to “POWER SUPPLY”) and turn on your unit
2. Press the SOURCE button of the unit or the remote control to select CD mode.
3. In CD mode, press the DOOR OPEN/CLOSE button to open the CD compartment and
insert a CD or CD-R/RW with the printed side facing up. Press the button again to close
the CD compartment.
4. The unit will read the files and then display the total number of tracks. Press the
PLAY/PAUSE button will start playback from the first track. During playback, the current
track number will be displayed.
Pause playback
Press the PLAY/PAUSE button to pause playback and triangle icon will flash. Press this
button again to resume playback.
Stop playback
Press the STOP button to stop playback. Then press the PLAY/PAUSE button to start
playback from the first track.
Search functions (Skip to next/ previous track)
During playback, press the SKIP/TUNE buttons to skip to the next / previous track.
Fast forward/backward
During playback, hold down SKIP/TUNE buttons to go fast backwards or forwards. Release
the button once you reach the required section. Normal playback will resume from that
point.
REPEAT playback (use in normal or program playback)
Press the REPEAT button repeatedly until RET icon flash on display. The unit will repeat
playing the desired track.
Press the REPEAT button repeatedly until RET icon light on display. The unit will repeat
playing the all track of CD.
Press the REPEAT button repeatedly until RET icon light off to cancel the repeat function.
PROGRAM playback
This function allows you to program up to 20 tracks to be played in the desired order.
Note: Programming can only be performed when playback is stopped.
Programming tracks
1. In STOP mode, press the PROG./MEM button that the “- -” will flash on display.
2. Use the SKIP/TUNE buttons to select a track number (digit flash on display).
3. Press the PROG./MEM button to confirm.
4. Repeat steps 2 and 3 to program other tracks
5. To play the program, press PLAY/PAUSE button.
6. To clear the program, press the STOP button twice, remove the CD or go to standby
mode.
USING THE CD
7