Curtis DRC8320N - Manual (Page 22)

Graphics contained within this publication are for representation only.
20
Chapter 1: Connections and Setup
Setting the Clock
Use the arrow buttons to enter the date and time. When fi nished, press ENTER to confirm and exit
this setting menu.
Setting the Signal Type
Completing this information lets the DVD/VCR know what program signals are being sent to it.
Choose the type of signal that is connected to the ANT IN jack.
CATV (cable service)
Antenna (no cable service, just off-air antenna)
Searching for Channels
The DVD/VCR automatically scans the signal coming through the cable connected to the ANT IN
jack and prepares the channel list. The channel list determines what channels appear when you press
the CH+ and CH- buttons.
A progress indicator appears on the TV. When the Channel Search reaches 100%, press ENTER.
Notes: If you are using only a cable box or satellite receiver, there will be few, if any,
channels in the channel list.
If you want to change any of these settings later, press SETUP to bring up the main
menu.
From the setup menu, use the arrow buttons to select "General" and then "Clock Setting" and then
press ENTER.
From the setup menu, use the arrow buttons to select "TV" and then "TV Signal". Use again the arrow
buttons to choose the setting. When finished, press ENTER to confirm and exit this setting menu.
From the setup menu, use the arrow buttons to select "TV" and then "Automatic Search" to start
the search.