Epson DX-TL4E - Manual (Page 21)

Four-Channel Digital Video Recorder
9
Chapter 3 — Configuration
NOTE: Your DVR should be completely installed before proceeding. Refer to Chapter 2 —
Installation.
Front Panel Controls
Figure 16 — DVR front panel.
Many of the buttons on the front panel have multiple functions. The following describes each
button and control. Take a few minutes to review the descriptions. You will use these to initially
set up your DVR and for daily operations.
NOTE: A separate Alarm button is not provided. Pressing any keys on the front panel or
remote control resets alarm output including the internal buzzer when the alarm is activated.
However, when you are in the menu or PTZ mode, you have to exit the menu or PTZ mode first
to reset alarm output.
NOTE: The sensor for the infrared remote control is just to the left of the PANIC button. Make
certain that nothing blocks the sensor, or the remote control will not function properly.
POWER LED
The POWER LED is lit when the DVR is On.
REC LED
The REC LED is lit when the DVR is recording. When the DVR is in the panic recording mode,
the REC LED flickers.
ALARM LED
The ALARM LED is lit when alarm output or internal buzzer is activated.