Curtis RCD882 - Manual (Page 9)

9
Getting Started
NOTE: If you have not done so already, please familiarise yourself with
the safety instructions and electrical information on pages 4 to 5,
before continuing with this section.
Remove your CD Radio Micro System carefully from the box. You may
wish to store the packaging for future use.
Connecting the Speakers
The speakers have integral cables. The ends of the cables are stripped
and soldered, ready for connection to the CD Radio Micro System.
The connectors on the rear of the CD Radio Micro System are marked
left (L) and right (R) and colored red and black. This corresponds to
the coloring of the cables.
Click open the
connectors as shown opposite. Insert the wires into the hole and
close the connector so that it clicks in place.
NOTE: Only insert the stripped part of the wires. If you insert too far the
connector may grip the insulation and not make contact with the wire.
Repeat this process using the upper connectors for the left speaker
wires.
Switching on
Your CD Radio Micro System requires a mains supply of 120 volts AC
at 60 Hz. Please ensure that your mains supply is compatible.
CAUTION! Applying power with the volume set near maximum
can cause damage to the speakers.
Your CD Radio Micro System is supplied with an integral mains power
cable and fitted plug.
CURTIS RCD882
9
Connect the LEFT speaker to the lower connectors, and connect
the RIGHT speaker to the upper connectors.