Curtis IP320UKT - Manual (Page 9)

7
MODEL : 48652
• User guide
• Remote control
www.curtisint.com
Changing the Lithium Battery
When the operation of the remote becomes intermittent
or the main unit no longer responds to the remote
commands, it is probably time to change the remote
battery.
Open the battery compartment by squeezing the battery
compartment-locking tab as shown and slide the battery
holder out of the battery compartment.
Remove the exhausted battery and install a fresh CR2025
battery in the battery holder with the “ + ” facing up as
shown, then slide the battery holder back into the battery
compartment.
Setting the Clock
a. With the power off, hold the CLK SET/ MEM button.
b. Press the FWD/TUNE or REV/TUNE buttons to toggle between 12HR and 24HR
time, and press the CLK SET/MEM button to select either option.
c. Press the FWD/TUNE button to cycle up through the hours, or press the REV/TUNE
button to cycle down through the hours. Press the CLK SET/MEM button to select
the hour.
d. Press the FWD/TUNE button to cycle up through the minutes, or press the REV/
TUNE down button to cycle down through the minutes. Press the CLK SET/ MEM
button to select the minute, and finish setting the time.
Operations