Curtis IP320UKT - Manual (Page 10)

8
MODEL : 48652
• User guide
• Remote control
www.curtisint.com
Setting the Alarm
a. Press the ALARM SET 1 button and the alarm icon show on display. Setting the
Alarm
b. Press and hold the ALARM SET 1 button.
c. Press the FWD/TUNE button to cycle up through the hours, or press the REV/TUNE
button to cycle down through the hours. Press the ALARM SET 1 button to select
the hour.
d. Press the FWD/TUNE button to cycle up through the minutes, or press the REV/
TUNE button to cycle down through the minutes. Press the ALARM SET 1 button to
select the minute.
e. Press the FWD/TUNE or REV/TUNE buttons to cycle through the different alarm
source (Radio, Buzzer, or iPod). After a mode is selected press the ALARM SET 1
button to finish setting the alarm.
Active or Deactivate the Alarm Function
a. To turn off the alarm completely(not reset for next day). Press and hold the AL 1
(AL 2) Button approx. 1 second then release. The AL 1 (AL 2) Indicator will disappear
on the display.
b. To active the alarm again at the same time . Press and hold the AL 1 (AL 2) Button
approx. 1 second then release. The AL 1 (AL 2) Indicator will appear on the display.
The alarm will goes off as the previously set time.
Warning:
This operation also applies to setting alarm two.
Alarm will not operation when the unit in power on mode.
If wake up mode was set to iPod (iPod/iPhone), make sure the iPod/ iPhone was inserted
in the docking properly and the volume was set to suitable level. Otherwise, when Alarm
goes off, no sound output from the speaker or sound weak.
When alarm sounding, press the POWER button to stop the alarm sound and the alarm
will automatic repeat next day.
•
•
•
•