Installation, Installing batteries, Standard installation – Curtis LCDVD2454A-B User Manual

Page 8

INSTALLATION

(1)Open the battery compartment cover on the back side
(2)Insert two 1.5V batteries of AAA type with correct polarity
(3)Close the battery compartment cover on the back side

Notes on using the Remote control.
Do not strike or drop the remote.
Do not expose the remote control to liquids and do not
place it in humid environment.
Do not install or place the remote control in direct sunlight.
The heat may damage the remote control.

INSTALLING BATTERIES

Notes on Using Batteries
The use of the wrong type of batteries may cause chemical
leaks and/or explosion.
Please note the following:
Always ensure that the batteries are inserted with the
positive and negative terminals in the correct direction
as shown in the batteries compartment. Different types
of batteries have different characteristics. Do not mix
different types. Do not mix old and new batteries.
Mixing old and new batteries will shorten battery life
and /or cause chemical leaks from the old batteries.
When batteries fail to function, replace them immediately.
Chemicals which leak from batteries may cause skin
irritation. If any chemical matter seeps out of the batteries,
wipe it up immediately using a dry cloth.
Due to varying storage conditions, the battery life for the
batteries included with your unit may be shortened.
If the remote control is not used for a long period of
time, remove the batteries.

INSTALLATION

STANDARD INSTALLATION

This is the default installation way of the TV.

25.4cm

Ensure that you connect the earth ground wire to prevent possible electric shock.
If grounding methods are not possible, have a qualified electrician install a separate circuit
breaker.

Do not try to ground the unit by connecting it to telephone wires, lightening rods or gas pipes.

a. Desktop Pedestal Installation

■The TV can be installed in various ways such as on a wall, or on a desktop etc.

■The TV is designed to be mounted horizontally.

Power

Supply

Short-Circuit

Breaker

(1) Secure the wall brackets with the bolts (not provided as parts of the product, must
purchase separately) on the wall. Match the height of the bracket that is mounted on
the wall. The wall bracket is of nomal dimension. Please see the position of the wall
brackets bolts as follow picture .The actual dimension of the wall brackts bolt should
according to the products.

The wall brackets bolt position

b. Wall Mount: Horizontal installation

10cm